236 Copying
Color
To select mode for color or black and white copying.
1
Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
For details about loading a document, see "Loading an Original Document on the ADF" on page 272.
2
Press the
(Copy)
button.
3
Press the
(Color Mode)
button to select the desired color mode.
4
Press the
(Start)
button to begin copying.
NOTE: If the Function Enabled setting for Copy is set to On(Color Password), you need to enter the four digit
password to use the copy function. If the Function Enabled setting for
Copy is set to Off, the copy function is disabled. For
details, see "Function Enabled" on page 197.
Collated
To sort the copy output: For example, if you make two copies of three page documents, one complete three page
document will print followed by the second complete document.
NOTE: Copying documents with a large amount of data may exhaust available memory.
If a memory shortage occurs, cancel the collating by turning Collated to Uncollated on the operator panel.
1
Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
For details about loading a document, see "Loading an Original Document on the ADF" on page 272.
2
Press the
(Copy)
button.
3
Ensure that
Collated
is highlighted, and then press the
(Set)
button.
4
Press
the button to select the desired setting, and then press the
(Set)
button.
NOTE: Values marked by an asterisk (
*
) are the factory default menu settings.
5
If necessary, customize the copy settings including the number of copies, contrast, and image quality. See "Setting
Copy Options" on page 235.
6
Press the
(Start)
button to begin copying.
Uncollated* Does not sort the copy job
Collated Sorts the copy job
Auto Automatically determines which output mode for the copy job
To Next Page
Loading...
Need help?
General
