Copying 237
Reduce/Enlarge
To reduce or enlarge the size of a copied image, from 25 percent to 400 percent when you copy original documents
from the document glass or ADF.
NOTE: When you make a reduced copy, black lines may appear at the bottom of your copy.
NOTE: This item is available only when Multiple-Up is set to Off or Manual.
1
Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
For details about loading a document, see "Loading an Original Document on the ADF" on page 272.
2
Press the
(Copy)
button.
3
Press the
button
until
Reduce/Enlarge
is highlighted, and then press the
(Set)
button.
4
Press the
button
to select the desired settings, and then press the
(Set)
button.
mm series
NOTE: Values marked by an asterisk (
*
) are the factory default menu settings.
inch series
NOTE: You can also use the numeric keypad to input the desired zoom ratio from 25% to 400%, or press the button to
enlarge the zoom ratio or press the button to reduce the zoom ratio in 1% intervals.
5
Press the
(Start)
button to begin copying.
200%
A5->A4(141%)
A5->B5(122%)
100%*
B5->A5(81%)
A4->A5(70%)
50%
200%
Stmt->Lgl(154%)
Stmt->Ltr(129%)
100%
*
Lgl->Ltr (78%)
Ldgr->Ltr(64%)
50%
To Next Page
Loading...
