266 Scanning
6
Click
Create
.
7
Enter a name and e-mail address in the
Name
and
E-Mail Address
fields.
8
Click
Apply New Settings
.
Sending an E-Mail With the Scanned File
1
Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass.
For details about loading a document, see "Loading an Original Document on the ADF" on page 272.
2
Press the
(Scan)
button.
3
Press the button until
Scan to E-Mail
is highlighted, and then press the
(Set)
button.
4
Ensure that
E-Mail to
is highlighted, and then press the
(Set)
button.
5
Press the button to select the setting listed below, and then press the
(Set)
button.
Keypad:
Type the e-mail address directly and then press the
(Set)
button.
Address Book
: Select the e-mail address registered in the E-Mail Address Book, and then press the
(Set)
button.
E-Mail Group
: Select the e-mail group registered in the E-Mail Groups, and then press the
(Set)
button.
NOTE: Users need to be registered before you can select Address Book on the operator panel.
6
Press the
(Start)
button to send e-mail.
To Next Page
Loading...
