Installing System Components | 187
LSI 9265-8i Card
NOTE: The LSI 9265-8i card assembly should include the
RAID Battery
interposer
card which is connected to the RAID battery. The illustrations in this section are
just for your removal and installation reference. For more information of the RAID
battery, see “LSI 9265-8i RAID Battery” on page 201.
Removing the LSI 9265-8i Card for 1U Node
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Remove the system-board assembly. See “Removing a System-Board
Assembly" on page 163.
2 Disconnect the two SAS/SGPIO cables connecting to the LSI 9265-8i
card assembly.
3 Remove the screws that secure the LSI 9265-8i card assembly. See
Figure 3-24.
4 Lift the LSI 9265-8i card assembly out of the system-board assembly.
See Figure 3-24.
To Next Page
Loading...
