240 | Installing System Components
Installing a System Board
1 Unpack the new system board.
2 Holding the system board by the edges, slide the system board into the
system-board assembly.
3 Replace the eight screws to secure the system board to the system-
board assembly.
4 Transfer the processors to the new system board. See “Removing a
Processor” on page 169 and “Installing a Processor” on page 171.
5 Remove the memory modules and transfer them to the same locations
on the new board. See “Removing the Memory Modules” on page 232
and “Installing the Memory Modules” on page 234.
6 Replace the heat sinks. See “Installing the Heat Sink” on page 169
7 Install the expansion-card assembly. See “Installing the Expansion
Card” on page 178.
8 If applicable, install the SAS mezzanine card, 1GbE mezzanine card, or
10GbE mezzanine card. See “Installing the LSI 2008 SAS Mezzanine
Card” on page 215, “Installing the 1GbE Mezzanine Card” on page 223
and “Installing the 10GbE Mezzanine Card” on page 227.
9 Connect all the cables to the system board.
10 Replace the air baffle. See “Installing the Air Baffle” on page 166
Replace the system-board assembly. See “Installing a System-Board
Assembly” on page 164.
To Next Page
Loading...
