EasyManuals Logo

Dell PowerEdge C6220 II Hardware Owner's Manual

Dell PowerEdge C6220 II
345 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #315 background imageLoading...
Page #315 background image
Troubleshooting Your System | 315
8 Reconnect the system to its electrical outlet, and turn on the system
and attached peripherals.
9 Enter the System Setup program and check the system memory
settings. See Main Screenon page 76.
If the problem is not resolved, proceed with the next step.
10 Turn off the system and attached peripherals, and disconnect the
system from the power source.
11 Remove the system-board assembly. See Removing a System-Board
Assemblyon page 163.
12 If a diagnostic test or error message indicates a specific memory
module as faulty, swap or replace the module.
13 To troubleshoot an unspecified faulty memory module, replace the
memory module in the first memory module socket with a module of
the same type and capacity. See Installing the Memory Moduleson
page 234.
14 Install the system-board assembly. See Removing a System-Board
Assemblyon page 163.
15 Reconnect the system to its electrical outlet, and turn on the system
and attached peripherals.
16 As the system boots, observe any error message that appears and the
diagnostic indicators on the front of the system.
17 If the memory problem is still indicated, repeat step 10 through step 16
for each memory module installed.
If the problem persists after all memory modules have been checked,
see Getting Helpon page 339.

Table of Contents

Other manuals for Dell PowerEdge C6220 II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerEdge C6220 II and is the answer not in the manual?

Dell PowerEdge C6220 II Specifications

General IconGeneral
Form Factor2U Rack
ProcessorIntel Xeon E5-2600 v2 series
Operating System SupportMicrosoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
MemoryUp to 512GB DDR3 per node
StorageUp to 24 x 2.5" hot-plug SAS, SATA, or SSD drives
NetworkDual 1GbE, optional 10GbE
ManagementDell Remote Access Controller (iDRAC7) with Lifecycle Controller
Number of ProcessorsUp to 2 per node (4 total in 2U chassis)
Power SupplyRedundant hot-plug power supplies

Related product manuals