Dell PowerEdge R660 - Removing the PCH shroud; Installing the PCH shroud

Removing the PCH shroud
Prerequisites
CAUTION: Never operate your system with the air shroud removed. The system may get overheated quickly,
resulting in shutdown of the system and loss of data.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE: The PCH shroud is installed on systems with no riser configuration.
Steps
Press the latches and lift the PCH shroud out of the system board.
Figure 66. Removing the PCH shroud
Next steps
1. Replace the PCH shroud.
Installing the PCH shroud
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE: The PCH shroud is installed on systems with no riser configuration.
Steps
1. Align the slots on the PCH shroud with the guide pins on the system board.
2. Press the latches and lower the PCH shroud on to the system board until it is firmly seated.
110
Installing and removing system components