Dell PowerEdge R660 - Removing the A2 Blank from the expansion card riser

Figure 178. Installing expansion card into the expansion card riser
NOTE: Push the card holder to hold the full length card in the riser.
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in After working inside your system.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing the A2 Blank from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove the air shroud.
4. Remove the expansion card riser.
NOTE: A2 blank is installed on Riser1p
Steps
1. Pull the black slide holder to release the A2 blank from the expansion card installed in the expansion card riser.
2. Push the circled tab and lift the A2 blank out from the expansion card riser.
Installing and removing system components
203