Figure 227. Removing the left control panel
Next steps
1. Replace the left control panel.
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the drive backplane cover.
4. If installed, remove the air shroud.
Steps
1. Align and slide the left control panel in the slot on the system.
2. Route the left control panel cable through the side wall of the system and slide the cable into the clip.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
3. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel to the system.
4. Connect the left control panel cable to the connector on the system board and secure it using cable latch.
Installing and removing system components
243
To Next Page
Loading...
