Dell PowerEdge R660 - Removing the BOSS-N1 card carrier blank; Installing the BOSS-N1 card carrier blank

Removing the BOSS-N1 card carrier blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
Press and pull the BOSS-N1 card carrier blank out from the BOSS-N1 module.
Figure 189. Removing the BOSS-N1 card carrier blank
Next steps
1. Replace the BOSS-N1 card carrier blank or install BOSS-N1 card carrier.
Installing the BOSS-N1 card carrier blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
212
Installing and removing system components