Dell PowerEdge R660 - Serial COM port kit

NOTE: Install a BOSS-N1 card carrier blank if you are only using one BOSS-N1 card carrier.
NOTE: Refer to cable routing section, configuration 20 for more information on connecting the BOSS cables to system
board connectors.
NOTE: Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 controller card module.
Serial COM port kit
The serial COM port kit contains the components that are listed in the table.
Table 118. Serial COM port kit
Components Quantity
Serial COM port card 1
Cable 1
For installation procedure of the serial COM port, see serial COM port section.
248 Upgrade Kits