Installing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If installed, remove the BOSS module blank.
Steps
1. Slide the BOSS-N1 cover on the BOSS-N1 controller card module. Using the Phillips #1 screwdriver, secure the BOSS-N1
cover on the BOSS-N1 controller card module with the M3 x 0.5 x 4.5 mm screw.
Figure 196. Installing the BOSS-N1 cover
2. Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
216
Installing and removing system components
To Next Page
Loading...
