NOTE: The procedure to remove the backplane is similar for all backplane configurations.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove the air shroud.
4. Remove the drive backplane cover.
5. Remove the drive carrier.
6. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
NOTE: Refer cable routing topic for more information.
Steps
1. Using a Phillips #1 screwdriver, loosen the captive screw on the backplane module.
2. Slide the backplane and lift it away from the system.
NOTE: To avoid damaging the backplane, ensure that you move the control panel cables from the cable routing clips
before removing the backplane.
Figure 88. Removing the 14 xEDSFF E3.S drive backplane
Next steps
1. Replace the 14 x EDSFF E3.S drive backplane.
Installing the 14 x EDSFF E3.S drive backplane
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove the air shroud.
4. Remove the drive backplane cover.
5. Remove the drive carrier.
6. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
128
Installing and removing system components
To Next Page
Loading...
