Figure 206. Installing the internal USB card
Next steps
1. Follow the procedure listed in After working inside your system.
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
VGA module
This is a service technician replaceable part only.
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If installed, remove the front bezel.
4. Remove the drive backplane cover.
5. If installed, remove the air shroud.
Steps
1. Disconnect the VGA cable from the connector on the system board.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace it to prevent the cables from being pinched or crimped.
2. Using Phillips #2 screwdriver, remove the screw on the VGA module.
3. Slide the VGA module out of the system.
224
Installing and removing system components
To Next Page
Loading...
