Dell PowerEdge R660 - Installing the A2 Blank on to the expansion card riser

Figure 179. Removing the A2 blank
Next steps
1. Replace the A2 blank on the expansion card riser.
Installing the A2 Blank on to the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove the air shroud.
4. Remove the expansion card riser
NOTE: A2 blank is installed on Riser1p
5. In not installed, Install the expansion card into the expansion card riser
Steps
1. Holding the edges or the touch points, align the holes on the A2 blank with the guides on the expansion card riser.
2. Slide the A2 blank until it is firmly seated on the expansion card riser.
3. Push the black slide holder forward to secure the A2 blank to the expansion card riser.
204
Installing and removing system components