NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 117. Removing the PERC card
Next steps
1. Replace the EDSFF E3.S PERC module.
Installing EDSFF E3.S PERC module and battery tray
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the drive backplane cover.
4. If installed, remove the air shroud.
5. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align and install PERC card to the guides on the front PERC tray.
2. Align and Install the PERC shroud on the PERC card.
3. Using a Phillips #2 screwdriver, tighten the four screws to secure the PERC shroud to the PERC tray.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
148 Installing and removing system components
To Next Page
Loading...
