Figure 118. Installing the H965 PERC module
4. Slide the PERC module until the module is connected to the drive backplane.
5. Using a Phillips #2 screwdriver, tighten the screws on the PERC module.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 119. Installing the PERC battery tray
6. Align and slide the PERC module and drive backplane to the chassis and ensure it engages with the guiding hole of the
chassis bracket.
7. Using a Phillips #2 screwdriver, replace the two screws on the chassis bracket.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 149
To Next Page
Loading...
