Dell PowerEdge R660 - BOSS-N1 module kit

BOSS-N1 module kit
The BOSS-N1 module supports up to two M.2 NVMe SSDs.
Before you begin the installation or removal process, follow the safety guidelines and before working inside the system
instructions.
Table 117. BOSS-N1 module kit components
Components in kit R660 (quantity)
BOSS-N1 controller card module 1
BOSS-N1 card carrier 1 or 2*
M.2 NVMe SSD 1 or 2*
M.2 NVMe SSD capacity label 1 or 2
†
BOSS-N1 card filler 1
M3 x 0.5 x 4.5 mm screws 3
BOSS-N1 power cable 1
BOSS-N1 signal cable 1
BOSS-N1 cover 1
NOTE: *The quantity depends on the purchase order.
NOTE:
†
The quantity depends on the BOSS-N1 card carrier
To remove the BOSS blank :
1. Power off the system and remove the system cover.
2. Using a Phillips #1 screwdriver, remove the screw that secures the BOSS-N1 module bay to the chassis.
3. Remove the blank from the BOSS-N1 module bay.
Figure 230. Removing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. To install the BOSS-N1 module, see installing the BOSS-N1 module.
2. To install the M.2 NVMe SSD and BOSS-N1 card carrier, see installing the BOSS-N1 module.
Upgrade Kits
247