EasyManua.ls Logo

Dell PowerEdge R660 - Drive backplane; Drive backplane connectors

Dell PowerEdge R660
269 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 81. Installing an EDSFF E3.S drive into the drive carrier
Next steps
1. Install the drive carrier.
Drive backplane
This is a service technician replaceable part only.
Drive backplane connectors
Depending on your system configuration, the drive backplanes supported are listed here:
Table 98. Supported backplane options
System Supported hard drives options
PowerEdge R660
2.5-inch (x 8) SAS or SATA or NVMe backplane
2.5-inch (x10) SAS or SATA or NVMe backplane
Figure 82. 8 x 2.5-inch drive backplane
1.
DST_PB2 (PCIe/NVMe connector) 2. DST_SB1
3. DST_PA2 (PCIe/NVMe connector) 4. BP_PWR_1 (backplane power and signal cable to system
board)
5. P8 6. DST_PB1 (PCIe/NVMe connector)
124 Installing and removing system components

Table of Contents

Related product manuals