Dell PowerEdge R660 - Removing the VGA port

Figure 180. Installing the A2 blank
Next steps
1. Replace the expansion card riser
2. If applicable, replace the air shroud.
3. Follow the procedure listed in After working inside your system.
Removing the VGA port
Prerequisites
1. Follow the safety guidelines listed in theSafety instructions .
2. Follow the procedure listed in Before working inside your system .
3. If applicable, disconnect the cables from the expansion card.
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Slide the VGA port out of the expansion card riser.
Installing and removing system components
205