Dell PowerEdge R660 - System memory; System memory guidelines

Figure 124. Installing the rear drive module
Next steps
1. If removed, install the expansion card riser
2. Connect all the cables to the rear drive module.
3. Install the rear drives.
4. If removed, replace the air shroud.
5. Follow the procedure listed in After working inside your system.
System memory
System memory guidelines
The PowerEdge R660 system supports DDR5 registered DIMMs (RDIMMs).
Your system memory is organized into eight channels per processor (two memory sockets per channel), 16 memory sockets per
processor and 32 memory sockets per system.
Installing and removing system components
153