Dell PowerEdge R660 - Installing the BOSS-N1 module blank

Figure 187. Removing the BOSS-N1 module blank
Next steps
1. Replace the BOSS-N1 module blank or install BOSS-N1 module.
Installing the BOSS-N1 module blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
1. Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
2. Using a Phillips #1 screwdriver, replace the screw to secure the BOSS-N1 module bay to the chassis.
Figure 188. Installing the BOSS-N1 module blank
Installing and removing system components
211