Dell PowerEdge R660 - Removing expansion card from the expansion card riser

Figure 171. Installing the expansion card riser (Riser 3)
Figure 172. Installing the expansion card riser (Riser 4)
Next steps
1. If required, re-connect the cables to the expansion card.
2. Follow the procedure listed in After working inside your system.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in theSafety instructions .
2. Follow the procedure listed in Before working inside your system .
3. If applicable, disconnect the cables from the expansion card.
198
Installing and removing system components