Steps
1. Pull and lift the expansion card retention latch lock to open.
NOTE: Pull the card holder before removing the card from the riser.
2. Hold the expansion card by the edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 173. Removing expansion card from the expansion card riser
Figure 174. Removing expansion card from the expansion card riser
3. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
Installing and removing system components
199
To Next Page
Loading...
