Dell PowerEdge R660 - Removing the expansion card risers

Table 115. Configuration 9. R2S+R3S(continued)
Card type Slot priority Maximum number of cards
Broadcom (OCP: 1Gb) Integrated slot 1
Intel (OCP: 1Gb) Integrated slot 1
Foxconn (BOSS) Integrated slot 1
Intel (GPU) 1, 3 2
Mellanox (NIC: NDR200) 1, 3 2
Mellanox (NIC: NDR400) 1, 3 2
Mellanox (NIC: HDR100 VPI) 1, 3 2
Mellanox (NIC: HDR VPI) 1, 3 2
Mellanox (NIC: 100Gb) 1, 3 2
Broadcom (NIC: 100Gb) 1, 3 2
Intel (NIC: 100Gb) 1, 3 2
Mellanox (NIC: 25Gb) 1, 3 2
Intel (NIC: 25Gb) 1, 3 2
Broadcom (HBA: FC64) 1, 3 2
Broadcom (HBA: FC32) 1, 3 2
Qlogic (Marvell) (HBA: FC32) 1, 3 2
Broadcom (NIC: 25Gb) 1, 3 2
Broadcom (NIC: 10Gb) 1, 3 2
Intel (NIC: 10Gb) 1, 3 2
Intel (NIC: 1Gb) 1, 3 2
Broadcom (NIC: 1Gb) 1, 3 2
FOXCONN (External Adapter) 1, 3 2
FOXCONN (External Adapter) 1, 3 1
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Disconnect any cables that are connected to the expansion card.
Steps
1. For Riser 1, press the blue tab and holding the edges lift the expansion card riser from the riser connector on the system
board.
194
Installing and removing system components