Figure 203. Removing the OCP card
Next steps
1. Replace the OCP card.
Installing the OCP card
Prerequisites
1. Remove the expansion card riser .
CAUTION:
Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
Steps
1. Open the blue latch on the system board.
2. Slide the OCP card into the slot in the system.
3. Push until the OCP card is connected to the connector on the system board.
4. Close the latch to lock the OCP card to the system.
Installing and removing system components
221
To Next Page
Loading...
