Dell PowerEdge R660 - SATA Settings

Table 45. Processor Settings details(continued)
Option Description
uncore power budgeting. This option is set to Enabled by
default.
Processor Core Speed Specifies the maximum core frequency of the processor.
Processor Bus Speed Specifies the bus speed of the processor.
NOTE: The processor bus speed option displays only when
both processors are installed.
Local Machine Check Exception Enables or disables the local machine check exception. This
is an extension of the MCA Recovery mechanism providing
the capability to deliver Uncorrected Recoverable (UCR)
Software Recoverable Action Required (SRAR) errors to one
or more specific logical processors threads receiving previously
poisoned or corrupted data. When enabled, the UCR SRAR
Machine Check Exception is delivered only to the affected
thread rather than broadcast to all threads in the system.
The feature supports operating system recovery for cases of
multiple recoverable faults that are detected close, which would
otherwise result in a fatal machine check event. The feature is
available only on Advanced RAS processors. This option is set to
Enabled by default.
CPU Crash Log Support This field controls Intel CPU Crash Log feature for collection
of previous crash data from shared SRAM of Out-of -Band
Management Service Module at post reset. This option is set
to Disabled by default.
Processor n
NOTE: Depending on the number of processors, there might
be up to n processors listed.
The following settings are displayed for each processor:
Table 46. Processor n details
Option Description
Family-Model-Stepping Specifies the family, model, and stepping of the processor as
defined by Intel.
Brand Specifies the brand name.
Level 2 Cache Specifies the total L2 cache.
Level 3 Cache Specifies the total L3 cache.
Number of Cores Specifies the number of cores per processor.
Microcode Specifies the processor microcode version.
SATA Settings
To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
SATA Settings.
Table 47. SATA Settings details
Option Description
Embedded SATA Enables the embedded SATA option to be set to Off, AHCI mode , or RAID modes.
This option is set to AHCI Mode by default.
NOTE:
1. You might also need to change the Boot Mode setting to UEFI. Otherwise, you
should set the field to Non-RAID mode.
Pre-operating system management applications 53