Dell PowerEdge R660 - Cooling fans; Removing a cooling fan module

Figure 67. Installing the PCH shroud
Next steps
1. Follow the procedure listed in After working inside your system.
Cooling fans
Removing a cooling fan module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove the air shroud.
Steps
Holding the orange (near the lable) and black (near the orange touch point) edges on the fan module, lift the cooling fan module
to disconnect from the connector on the system board.
NOTE: The procedure to remove standard (STD) or high performance gold (HPR Gold) dual cooling fan modules are same.
Installing and removing system components 111