3. System board 4. Expansion riser 2
5. Intrusion switch module 6. Rear I/O board
7. Power supply unit (PSU1 and PSU2) 8. LOM card or MIC card
9. Heat sink for optional processor 2 or processor 2 blank 10. Memory DIMM sockets
11. Backplane 12. Information tag
Figure 15. Inside the system view
1.
Cooling fans 2. Air shroud
3. Heat sink for processor 1 4. Intrusion switch module
5. Rear I/O board 6. Power supply unit (PSU1 and PSU2)
7. BOSS-N1 module 8. OCP NIC ports (optional)
9. LOM card or MIC card 10. Heat sink for optional processor 2 or processor 2 blank
11. Memory DIMM sockets 12. Backplane
13. Information tag
Locating the Express Service Code and Service Tag
The unique Express Service Code and Service Tag are used to identify the system.
The information tag is located on the front of the system that includes system information such as the Service Tag, Express
Service Code, Manufacture date, NIC, MAC address, QRL label, and so on. If you have opted for the secure default access
to iDRAC, the Information tag also contains the iDRAC secure default password. If you have opted for iDRAC Quick Sync
20
PowerEdge R660 system overview
To Next Page
Loading...
