Figure 120. Installing the PERC battery tray
8. If removed, install battery holder, by placing the PERC battery holder between the E3.S backplanes.
9. Using a Phillips #2 screwdriver, tighten the captive screw on the PERC battery holder.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 121. Installing the PERC battery holder
10. Align and insert the hooks on the battery to the holes on the battery holder and press down the battery to install the PERC
battery on to the holder.
11. Route the power cable and connect it to the PERC power connector.
150
Installing and removing system components
To Next Page
Loading...
