5. Using a Phillips #2 screwdriver, remove the screws on the chassis bracket.
6. Slide and lift the PERC module and drive backplane to disengage from the chassis.
Figure 115. Removing the PERC module
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
7. Using a Phillips #2 screwdriver, remove the two screws on the PERC module.
8. Slide the PERC module to disengage from the connector on the drive backplane.
Figure 116. Removing the PERC module
9. Using a Phillips #2 screwdriver, remove the four screws on the front PERC shroud.
10. Remove the PERC shroud from the PERC.card.
11. Remove the PERC card from the PERC tray.
Installing and removing system components
147
To Next Page
Loading...
