Figure 97. Removing the front mounting front PERC card
5. Use a Phillips #2 screwdriver, to remove the four screws on the battery PERC shroud.
6. Disconnect the battery power cable from the front PERC card.
7. Remove the battery PERC shroud from the front PERC.card.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 98. Removing the battery PERC shroud
8. Remove the front PERC card from the PERC mounting tray.
136
Installing and removing system components
To Next Page
Loading...
