Figure 100. Installing the front PERC card to the PERC mounting tray
3. Align and install the battery PERC shroud on the front PERC.card.
4. Connect the battery power cable to the front PERC card.
5. Using a Phillips #2 screwdriver, replace the four screws to secure the battery PERC shroud to the front PERC card.
Figure 101. Installing the battery PERC shroud
6. Connect PERC power cable to the front PERC card.
7. Align the holes on the PERC power cable bracket with the holes on the PERC mounting tray.
8. Using a Phillips #2 screwdriver, replace the two screws on the PERC power cable bracket.
9. Align the PERC mounting tray until the tray touches the guide slots in the system. Slide the front PERC card towards the
lock to secure it and ensure the plunger is engaged in to the hole on the system.
10. Connect the power cable to the backplane. For detailed cable routing instructions, see the cable routing section.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
138 Installing and removing system components
To Next Page
Loading...
