Figure 103. Removing the rear mounting front PERC module
3. Using a Phillips #2 screwdriver, remove the three screws securing the front PERC module bracket to the drive backplane.
4. Disconnect the battery power cable from the front PERC card.
5. Tilt and lift the battery holder assembly from the front PERC shroud.
NOTE: Remove the battery cable from the front PERC shroud cable holder.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 104. Removing the battery holder assembly from the PERC shroud
6. Press and remove the battery from the battery holder.
140
Installing and removing system components
To Next Page
Loading...
