Dell PowerEdge R660 - Page 214

3. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1
card carrier.
4. Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
Figure 192. Removing the M.2 NVMe SSD
5. Press the metal clip to remove the BOSS-N1 signal cable from the system board.
6. Disconnect the BOSS-N1 power cable from the system board.
7. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screws that secures the BOSS-N1 module .
8. Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Figure 193. Removing the BOSS-N1 module
9. Press the metal clip to remove the BOSS-N1 signal cable from the BOSS-N1 module.
214
Installing and removing system components