Dell PowerEdge R660 - Page 57

Table 52. Network Settings details(continued)
Option Description
Host Security Key Path This field specifies the Host security key path.
NVMe-oF SubSystem Settings This field controls the parameters for the NVMe-oF subsystem n
connections.
Table 53. PXE Device n Settings details
Option Description
Interface Specifies NIC interface used for the PXE device.
Protocol Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to
IPv4 by default.
Vlan Enables Vlan for PXE device. This option is set to Enabled or Disabled. This option is set to
Disabled by default.
Vlan ID Shows the Vlan ID for the PXE device
Vlan Priority Shows the Vlan Priority for the PXE device.
Table 54. HTTP Device n Settings details
Option Description
Interface Specifies NIC interface used for the HTTP device.
Protocol Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set
to IPv4 by default.
Vlan Enables Vlan for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
Vlan ID Shows the Vlan ID for the HTTP device
Vlan Priority Shows the Vlan Priority for the HTTP device.
DHCP Enables or disables DHCP for this HTTP device. This option is set to Enabled by default.
IP Address Specifies IP address for the HTTP device.
Subnet Mask Specifies subnet mask for the HTTP device.
Autoconfiguration Enables or disables the IPv6Autoconfiguration for the HTTP Device. When set to Enabled,
IPv6 Address and Gateway are retrieved from Autoconfiguration mechanism.
Prefix Length IPv6 Prefix Length (0~127) for this HTTP Device.
IPv6 Address IPv6 Unicast address for this HTTP Device.
Gateway Specifies gateway for the HTTP device.
DNS info via DHCP Enables or disables DNS Information from DHCP. This option is set to Enabled by default.
Primary DNS Specifies the primary DNS server IP address for the HTTP Device.
Secondary DNS Specifies the secondary DNS server IP address for the HTTP Device.
URI (will obtain from
DHCP server if not
specified)
Obtain URI from the DHCP server if not specified
TLS Authentication
Configuration
Specifies the option for TLS authentication configuration.
NOTE: Autoconfiguration, Prefix Length and IPv6 Address options are visible only when Protocol is set to IPv6
Pre-operating system management applications 57