Configure: Drive
The following items are in this menu:
v Drive Interface - use this to assign a SCSI ID to a SCSI drive or to assign a Port
Speed, Port Type, and Loop ID to a Fibre Channel drive. SAS drives do not
require user configuration. For more information on drive interfaces, refer to
“Host Interfaces” on page 3-7.
v Control Paths - use this to enable the drive as a control path drive. Each logical
library must have a control path drive; however, all drives in a logical library
can be designated as control path drives.
Configure
Drive Interface
Control Path
Drive
a77ug042
SCSI IDSAS drives
do not
require user
configuration
A Speed
A Type
A Address
Mode
A Loop ID
Fibre Channel Drive
Figure 5-15. Configure: Drive menu
Chapter 5. Operations 5-23
To Next Page
Loading...
