The Admin login has access to all library functions except Service Library →
Advance Diagnostics.
The Service login has access to all library functions including Service Library →
Advance Diagnostics.
1. Click Configure Library → User Access in the left navigation pane.
2. Check the Disable Superuser checkbox to disable the Superuser role for this
library. Check the Disable User checkbox to disable the User role for this
library. Uncheck these boxes to allow these roles access to your library.
3. Choose a Role.
Note: Admin can select User, Superuser, and Admin roles. Service can select
User, Superuser, Admin, and Service roles.
v User (if enabled)
v Superuser (if enabled)
v Admin
v Service
Note: Only one password can be set for each Role.
4. Enter the New Password . The password has a maximum of 10 characters (A-Z,
a-z,
0-9,
@,
<hyphen>,
<space>,
<period>).
5. In Repeat Password, enter the new password again.
6. In Support Name, enter the name of the person that will be able to offer the
user help with the library.
Note: Only one support person can be configured for the entire tape library.
The support person may or may not be one of the user, superuser, or
admin account holders.
7. In Support Phone, enter the phone number of the person that will be able to
offer the user help with the library.
8. In Support Email, enter the email address of the person that will be able to
offer the user help with the library.
9. Click one of the following:
v Refresh - to update the current screen.
v Submit - to apply the changes made to the screen.
Figure 4-28. The Configure Library: User Access screen
Chapter 4. Installation and Configuration 4-27
To Next Page
Loading...
Need help?
General
