b. For a desktop library:
1) Carefully, lay the library on its side.
2) Peel the adhesive from the back of each of the six foot pads.
3) Install the foot pads on the bottom of the library enclosure by pressing
each foot into one of the six areas (1) as shown in Figure 10-13.
3. Carefully return the library to an upright position.
4. Remove the shipping lock from the top of the replacement library enclosure
(see Figure 10-14 on page 10-16).
1
a77ug085
Figure 10-13. Foot pads installed on the bottom of the library enclosure
Chapter 10. Check, Adjust, Remove, and Replace 10-15
To Next Page
Loading...
