Table 5-6. Library Identity page elements (continued)
Menu Item Description 2U 4U
WWide Node
Name
This is the Worldwide Node Name assigned to your library. X X
Logical Library x
Library Mode
The Extended Logical Libraries Information table displays information
about the logical libraries currently assigned in your library. For each
logical library in your library, either Random or Sequential Loop
Autoload will be displayed.
XX
This view is correct for a library with multiple logical partitions. The Library
Identify screen will be different for a library with a single logical partition.
Monitor Library: Drive Identity
This page provides the following detailed information about the drive. No changes
can be made from this page. The displayed information will vary depending on
the library model and drive type (SCSI, SAS, or Fibre Channel). Table 5-7 lists all
available elements on the Drive Identity page. An "X" indicates that the element
displays for the specified drive type.
Table 5-7. Drive Identity page elements
Menu Item Description 2U Library 4U Library
SCSI Fibre SAS SCSI Fibre SAS
Vendor ID This identifies the manufacturer of the tape drive. X X XXXX
Product ID This is the SCSI inquiry string of the tape drive. X X XXXX
Serial
Number
This is the unique identification number of the tape
drive that was assigned by the manufacturer.
XXXXXX
Firmware
Revision
This is the current level of firmware installed on the
drive. For information on updating your firmware, refer
to “Service Library: Upgrade Firmware” on page 5-62.
XXXXXX
Figure 5-26. The 4U library Monitor Library: Library Identity page
Chapter 5. Operations 5-35
To Next Page
Loading...
