Tables
1. Minimum Firmware Levels for common
Library features ..........iii
1-1. 2U library and 4U library front panel
descriptions ...........1-2
1-2. 2U library and 4U library rear panel
descriptions ...........1-4
1-3. Tape drive model and host interface type 1-8
1-4. Library storage capacity and data transfer
rate ..............1-8
1-5. Physical Specifications........1-11
1-6. Power Specifications ........1-11
1-7. Operation Specifications: Ultrium 5 1-11
1-8. Operation Specifications: Ultrium 4 1-11
1-9. Operation Specifications: Ultrium 3 1-12
1-10. Environmental Specifications .....1-12
3-1. Host Drive Interface Support ......3-7
3-2. Maximum bus length between terminators 3-8
3-3. Recommended maximum quantity of drives
perSCSIbus...........3-8
4-1. Location criteria ..........4-1
5-1. Menu navigation shortcuts ......5-1
5-2. Library Control Keys ........5-8
5-3. Detailed information on cartridges residing
in a magazine ..........5-16
5-4. Factory Default Settings .......5-28
5-5. Web User Interface Menus ......5-33
5-6. Library Identity page elements .....5-34
5-7. Drive Identity page elements .....5-35
5-8. Library Status page elements .....5-37
5-9. Drive Status page elements ......5-38
5-10. Configure Library: General page elements 5-44
5-11. Configure Library: Specific page elements 5-44
5-12. Drive Identity page elements .....5-49
6-1. Nominal Cartridge Life: Load/Unload
Cycles .............6-2
6-2. Ultrium data cartridge compatibility with
Ultrium tape drive .........6-2
6-3. Cartridges and VOLSERs compatible with
the Ultrium Tape Drives .......6-4
6-4. Location of the write-protect switch 6-6
6-5. Environment for operating, storing, and
shipping the LTO Ultrium Tape Cartridge . 6-10
7-1. Troubleshooting table ........7-1
7-2. Power Supply LED Meanings .....7-8
8-1. Main Error Codes .........8-2
8-2. Sub error codes ..........8-7
8-3. Warning Events ..........8-11
10-1. Shipping Lock/Shipping Label .....10-2
A-1. 2U library SCSI Element Types and
Element Addresses .........A-1
A-2. 4U library SCSI Element Types and
Element Addresses .........A-1
A-3. 2U library SCSI element addresses for
storage slots and drive slot (one logical
partition with one drive) .......A-2
A-4. 4U library SCSI element addresses for
storage slots and drive slot (one logical
partition with drives in slot 1 and slot 2) . A-2
B-1. TapeAlert Flags Supported by the Ultrium
Tape Drive ............B-2
C-1. Library Sense Keys, ASC and ASCQ C-1
C-2. LTO Tape Drive Sense Data ......C-6
F-1. SNMP Status Events ........F-1
xi
To Next Page
Loading...
Need help?
General
