v With every library containing a SAS drive:
– SAS library-to-host cable (if ordered by customer)
v Rack Mount Kit
Installing the Library Foot Pads (for Desktop Installation
ONLY)
If you intend to install your library in a rack, skip this step and proceed to
“Removing and Storing the Shipping Lock” on page 4-4.
Important: Operating your library on a flat surface without foot pads may damage
your library or cause it not to function properly.
Six foot pads must be installed on the bottom of the library before the library can
be used as a desktop unit.
To install the library foot pads:
1. Being very careful, lay the library on its side.
2. Peel the adhesive from the back of each foot pad.
3. Install the foot pads on the bottom of the library enclosure by pressing each
foot into one of the six areas (1) as shown in the figure below.
Chapter 4. Installation and Configuration 4-3
To Next Page
Loading...
