7. Select Enable SSL for EKM to enable Secure Sockets Layer for the Dell
Encryption Key Manager application.
8. Select an Encryption method, from the pull down menu, for each logical
library.
v Without an encryption license key, select None or Application Managed
Encryption.
v With an encryption license key, select Library Managed Encryption.
9. Select an Encryption policy, from the pull down menu, for each logical
library.
v Encrypt All: This is the default policy. It encrypts all cartridges using the
default data keys specified in the EKM. This setting applies to all drives in
the TL2000/TL4000 logical library.
v Internal Label - Selective Encryption: Check your tape backup software
application documentation to see if this feature is supported.
v Internal Label - Encrypt All: Check your tape backup software application
documentation to see if this feature is supported.
10. A primary and secondary EKM server can be set for each logical library. Each
partition has its own Encryption and EKM settings. Maintaining primary and
secondary EKM servers is desired for maximum availability of encrypted
backup and recovery. These settings are required for Library Managed
Encryption only. Enter the EKM Server Setting information.
v Primary IP address (IPv4 or IPv6): Enter the IP address of the primary
EKM server.
v Primary TCP port: After entering the Primary IP address, the library will
automatically set the value of the Primary TCP port.
v Secondary IP address (IPv4 or IPv6): Enter the IP address of the secondary
EKM server.
a77ug190
Figure 5-40. Configure Library: Encryption Feature configuration screen
5-48 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
To Next Page
Loading...
Need help?
General
