Table 8-2. Sub error codes (continued)
94 Sled movement to home sensor position failed.
95 Sled movement to transport position failed.
A0 Movement of I/O slot failed.
A1 Sled movement to sensor failed.
A2 Sled movement to rotation position failed.
A3 Elevator movement to home position failed.
A4 Error during rotation to far position.
A5 Sled movement to I/O slot position failed.
A6 Error during elevator movement to position
B0 EEPROM on robotics controller not accessible or error during Read/Write operation
LIBRARY
81 Drive wake up failed
88 Error accessing slot status
90 Accessor load not reached Cartridge Present sensor
91 No activity after Load command
92 Timeout while loading tape
93 No activity after load command
94 Timeout drive Unload
95 Drive terminated unsuccessfully
96 Tape not ejected at robot unload
97 Slot not free at robot unload
98 Cartridge not seated in load phase
Warning Events
Warning events described in this section are reported via email notification. The
Attention LED will blink when warning events for the following occur:
v Media
v Fan
v Redundant power supply
An appropriate message will be posted on the Operator Control Panel and the Web
User Interface.
8-10 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
To Next Page
Loading...
