Figure 31. Installing the M.2 2230 SSD
Steps
1. Place the M.2 2230 SSD mounting bracket in space.
NOTE:
For models shipped with M.2 2230 SSD, ensure that the SSD screw holder is transferred when the system board
is replaced.
2. Align the notch on the M.2 2230 SSD with the tab on the M.2 2230 SSD slot.
3. Replace the screw (M2x4) that secure the M2.2230 SSD in place.
4. Place the SSD shielding cover over the M.2 2230 SSD and replace the two screws (M2x3) to secure it in place.
Next steps
1. Install the base cover.
2. Install the SIM card tray, if applicable.
3. Follow the procedure in after working inside your computer.
Removing the M.2 2280 solid state drive
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the sim-card tray, if applicable.
3. Remove the base cover.
About this task
The following images indicate the location of the solid state drive and provide a visual representation of the removal procedure.
56
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
