NOTE: When installing the clip to secure the MIPI camera connection to the middle daughter board cable, ensure that
the top side (with “TOP” etched on it) is facing up.
Next steps
1. Install the display panel .
2. Install the display bezel.
3. Install the display assembly.
4. Install the WWAN.
NOTE: This procedure applies only to computers shipped with a WWAN card installed.
5. Install the base cover.
6. Install the SIM card tray, if applicable.
7. Follow the procedure in after working inside your computer.
Camera
Removing the camera and display cable
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the sim-card tray, if applicable.
3. Remove the base cover.
4. Remove the WWAN.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel .
About this task
NOTE: This procedure applies for only models that are shipped with an RGB or IR camera.
The following images indicate the location of the camera and display cable and provide a visual representation of the removal
procedure.
88
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
