Dell Pro 14 Plus - Fan; Removing the Fan

Figure 35. Installing the speakers
Steps
1. Using the alignment posts and rubber grommets, place the speakers into the slots on the palm-rest and keyboard assembly.
NOTE: To properly position the speakers, secure the rubber grommets into the hooks.
2. Replace the six screws (M1.6x1.5) that secure the speakers in place.
3. Route the speaker cable along the bottom side of the palm-rest and keyboard assembly and secure the speaker cable into
the routing guides on the palm-rest and keyboard assembly.
4. Connect the speaker cable to the connector on the I/O board.
Next steps
1. Install the base cover.
2. Install the SIM card tray, if applicable.
3. Follow the procedure in after working inside your computer.
Fan
Removing the fan
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the sim-card tray, if applicable.
3. Remove the base cover.
60
Removing and installing Customer Replaceable Units (CRUs)