Dell Pro 14 Plus - Installing the Display Back Cover

Figure 62. Removing display assembly back cover
Installing the display back cover
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation
procedure.
Next steps
1. Install the display hinge cap and hinge assembly.
2. Install the MIPI camera cable (for models shipped with MIPI camera).
3. Install the camera cable (for models that are shipped without camera or with RGB or IR camera).
4. Install the display panel.
5. Install the display bezel.
6. Install the display assembly.
7. Install the WWAN.
NOTE: This procedure applies only to computers shipped with a WWAN card installed.
8. Install the base cover.
92
Removing and installing Field Replaceable Units (FRUs)