Denso BHT-1505B - Communications Parameters

193
Barcode Handy Terminal
5.4.2 Communications Parameters
In System Mode and user programs written in BHT-BASIC, you can set the communications parameters
listed below.
Port
IrDA Interface
Transmission speed
9600, 19200, 38400, 57600, 115200,
460800
(Note)
bps
Character length
8 bits
Vertical parity
None
Stop bit length
1 bit
Note: 460800 bps can be used only for the communication between the BHT-1500s.
 System Mode
Refer to Chapter 4 “System Operation” – “4.5.6 Set System Menu.”
 BHT-BASIC
To set the transmission speed, character length, vertical parity, and stop bit length (For the IrDA interface,
set the transmission speed only), use the OPEN "COM: " statement in BHT-BASIC.
OPEN "COM: ... "
OPEN "COM1: ... "
Through the interface port opened by the OPEN "COM: " statement, the XFILE statement transmits a
designated file.