Denso BHT-1505B - Detailed Settings for Codabar (NW-7)

90
BHT-1500B series
“3: CODABAR”: Detailed settings for Codabar (NW-7)
1. Select “3: CODABAR” at the SET BARCODE menu and then press
the ENT key.
The SET CODABAR screen is displayed.
“1: MIN”:
Set minimum number of digits of Codabar
Setting range: 3–99
“2: MAX”:
Set maximum number of digits of Codabar
Setting range: 3–99
- Point - Make sure that the minimum number of digits is less than the
maximum number of digits. If
the value of minimum number of digits is larger than the maximum number of digits, er
ror
occurs during the reading.
“3: START CODE”:
“4: STOP CODE”:
Allocate “?, A, B, C, D” to start/stop code of Codabar.
If “A, B, C, D” is allocated at the menu, limitation is set for the BHT to read only when allocated
characters match to the characters of CODABAR. The BHT will carry on reading endlessly if “?” is
allocated.
“5: CD CHECK”:
“ON”: Reading is impossible when check digits are incorrect or missing.
“OFF”: Reading is performed regardless of the use of check digits.
2. Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4] [5]) to select the item to be set.
3. Use the cursor keys ([◄] [►]) to select settings value.
4. Press the ENT key or BS/C key for the settings value to be valid and then return to the SET
BARCODE screen.